SBIG - 8-position 50mm filter wheel without filters for STL series cameras (replaces the front cover and 5-position filter carousel)

Features:

    * Holds up to eight 50mm drop in filters, or 48mm threaded filter cells, or any combination.
    * Thin design - adds only about 0.35" backfocus to current design.
    * Internal ROM for easy installation in the field.
    * Mates to STL camera body with existing bolt pattern for rigid integrated mechanical interface.
    * Uses existing connector and I2C port for power and commands.  No additional cable to computer or power supply is required.
    * Compatible with new large format AO-L adaptive optics accessory for STL cameras.

The new FW8-STL for the STL series cameras is now shipping.  It is a single carousel design that is thinner but wider than a
double carousel design.  The existing accessory plate and bolt pattern on the front cover of the camera are brought to the front
of the filter wheel so that any existing custom accessories made to fit the camera will also fit the new filter wheel.  Compared
to the existing filter wheel and cover, there is an increase of approximately 0.35" in backfocus with the new filter wheel
installed.  The drawing below shows the approximate dimensions of the new cover with internal carousel.

The new filter wheel is a simple replacement cover for the camera.  It holds eight 50mm drop-in filters (or 48mm threaded filter
cells).  It picks up the existing connector and bolt pattern in the main body and is controlled through the I2C port.  A short
jumper cable to the I2C port is the only external cabling required.  All power and commands come from the camera and can be
controlled remotely via software without any other external cable running to the computer or power supply.  The FW8-STL also has
its own ROM and electronics so the camera does not have to be returned to SBIG for re-programming to control the different filter
wheels.   Once the camera drivers are updated by free download from our web site, the user can simply remove the existing cover
and replace it with the new one.