Denkmeier - #S2 Silver Enhanced Power x Switch Star Diagonal Regular

Diagonal #S2 For SCTs

Allows Binoviewers to be used in SCTs for instant normal, reduction and multiplication factors. Single eyepieces can also be used
with #S2 though the reduction and multiplication factors are lowered unless the eyepiece is withdrawn outward from the star
diagonal.

Load And Go

With #S2, the Power x Switch is an integrated device so your Denk does not need a Power x Switch attached to it. Your binoviewer
or single eyepieces can be swapped at any time and the Power x Switch stays in the diagonal. We include an SCT thread-on visual
back adapter with #S2. For SCTs that are smaller than 10", be sure to select the "Shorty" version so that the fork base will be
cleared when you want to observe near zenith. For the 8" LX90, choose this diagonal (instead of #S1) even if single eyepieces-only
are to be used as this scope has less clearance than typical 8" SCTs.

Focal Reduction

A special Dovetail Connector is also included for SCTs that may have less backfocus like the 14" Meade or the C9.25" by
Celestron. Most SCTs tube assemblies vary in the amount of backfocus that they can deliver so it is impossible to predict with
accuracy whether the focal reduction mode of #S2 will allow focus with a binoviewer. Almost all F/10 SCTs will reach focus without
a problem, especially when the included Dovetail Connector is utilized. Reduction when using single eyepieces is a sure thing and
requires much less backfocus.