BobsKnobs - KNOBS FOR ORION XT SERIES NEWTONIAN SECONDARY WITH FACTORY SET SCREWS

COLLIMATE YOUR SCHMIDT-CASSEGRAIN STYLE OR NEWTONIAN STYLE TELESCOPE WITHOUT TOOLS

It′s easy . . . just grab a Bob′s Knob and turn. You can even do it while looking through the eyepiece on most
scopes. And you′ll never drop that pesky little Allen wrench or screwdriver into the grass again. Installation is a snap
with the included instructions, and you can undo the modification at any time.

Fits: All Orion XT and similar (SkyQuest, SkyView, SkyWatcher) Newtonian secondary with factory set screws

Knobs: Black plastic, 13 mm (1/2 inch) diameter

Threads: Stainless steel

Note1: The factory dust cover will fit normally with Bob′s Knobs installed.

Note2: These knobs will fit many similar Newtonian secondary assemblies with factory M4 set screws. If your secondary
looks like this, our knobs will probably fit.